Browse Instructions
How To Replace A Basement Window
Posted By: PDogg;
Category: Home Improvement & Gardening;
October 27, 2008
Author PDogg;
Here are some basic steps to replace your basement window.
Click Image To Enlarge
1
You will need the following tools:
* Hammer
* Tape measure
* Utility knife used to trim shims
* Cold chisel used to chip away old mortar from window opening
* Caulking gun
* Whisk broom used to sweep away debris
* Drill/driver used to drive screws
* Reciprocating saw
* Hammer
* Tape measure
* Utility knife used to trim shims
* Cold chisel used to chip away old mortar from window opening
* Caulking gun
* Whisk broom used to sweep away debris
* Drill/driver used to drive screws
* Reciprocating saw
Click Image To Enlarge
2
Remove the sash from existing basement window.
Click Image To Enlarge
3
Use reciprocating saw to cut through the window frame.
Click Image To Enlarge
4
Pull out the old window frame from wall opening.
Click Image To Enlarge
5
Use hammer and cold chisel to chip away mortar from sides of opening, if necessary.
Click Image To Enlarge
6
Slide new window into the opening.
Click Image To Enlarge
7
Use shims to center new window in the opening. Secure window by screwing up through its frame and into the mudsill.
Click Image To Enlarge
8
From outside, apply caulk along the sides and top of the window frame.
Click Image To Enlarge
9
Spray urethane foam under the sill to seal the bottom of the window.
Click Image To Enlarge
10
Apply a coat of exterior-grade primer to all bare wood window parts, followed by two paint topcoats, and you have finsihed replaceing your basement window.
Only registered users can add comments
